Oki 5700 User Manual download pdf (Page 86)

English

6-6 Chapter 6

after a programmed ring pattern is detected. If no ring pattern has been

programmed, the ring pattern defined for each country is used for detection

as the default setting. Available settings are ON (detected), OFF (not

detected) and SET (programmed). Speed access no. 67

Note:

The default setting (factory setting) is ON for the following countries

only: USA, AUS, NZL, SEN and HNG. All other countries must learn

the ring pattern using SET before being able to set the machine to

ON.

Changing Operation Functions

Press MENU/EXIT to enter the menu.

Input the speed access number of the parameter to be changed, wait.

When the display for the desired parameter is shown, use the SHIFT

keys to select the setting (or input data where required), press ENTER.

Press MENU/EXIT to return to standby mode.

Repeat steps 1-4 until finished setting parameters.

Memory Password

This is a 4-digit numeric password used when the machine is operating in

the Memory Only Reception Mode (MEM). People who do not know the

password cannot make changes to or print memory data when the machine

is in this mode. Registration of just one password is possible. Speed access

no. 04.

To Set or Clear Memory Password

Press MENU/EXIT to enter the menu.

Input speed dial access no. 04, wait.

Input 4-digit numeric password using numeric keypad, press ENTER.

If there is no current password registered, this password will now be

registered, and the machine will return to standby mode.

If there was a password registered previously and you have entered it

correctly, display will show “PASSWORD CLOSE?” If numbers do

not match, display will show “INVALID PASSWORD”. At

“PASSWORD CLOSE” press ENTER to confirm password

cancellation., then press MENU/EXIT to return to standby mode.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 133 134

No comments

Oki 5700 User Manual Page 86