Oki Pos 441 User Manual download pdf (Page 31)

– 27 –

(3) To adjust, use the FEED switch to select the adjustment pattern from the printout with the

smallest gap between the ﬁrst printing pass and the return printing pass. Press the FEED

switch once to specify the ﬁrst adjustment pattern, twice to specify the second adjustment

pattern, and so on up to seven times to specify the seventh adjustment pattern.

At the number that you want to specify, press and hold (2 seconds) the FEED switch until

the long buzzer sounds. This will specify the setting value. (For example, if you want to

select the eighth pattern from the top, press the FEED switch seven times. Then, at the eighth

pattern, press and hold (2 seconds) the FEED switch until the long buzzer sounds.)

There are only twenty three adjustment patterns. The buzzer will sound each time the FEED

switch is pressed. However, if you press the FEED switch more than twenty three times, a

warning alert will sound.

(4) If there is no matching pattern among the adjustment patterns, perform the “Backward” or

“Forward” operation described below in order to print a printing pattern in which the dot

alignment settings are changed. Then, repeat step (3).

Backward:

Press and hold the FEED switch for 2 to 4 seconds. The buzzer will beep, and the

printer will print a pattern in which the forward is adjusted more leftward of the pres-

ently indicated pattern and the backward is adjusted more rightward.

Forward:

Press and hold the FEED switch for 4 seconds or longer. The buzzer will beep-beep,

and the printer will print a pattern in which the forward is adjusted more rightward

of the presently indicated pattern and the backward is adjusted more leftward.

(5) After selecting the adjustment pattern, the setting value is stored in the non-volatile memory.

A printout similar to the one below with the selected adjustment pattern highlighted and

the message “Adjust Completed!” will be printed.

Note: Before the printout is printed, the setting value is stored in the non-volatile memory

of the printer after the adjustment pattern has been selected and the long buzzer

sounds. During this period, do not set the power switch to off. If this power switch

is set to off when the setting value is being stored in the non-volatile memory, the

setting value for the adjustment pattern and all of the memory switch settings will

be reset.

(6) The long buzzer sounds once more and the setting value is automatically set.

The adjusting the dot alignment mode is complete.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

No comments

Oki Pos 441 User Manual Page 31