Oki Pos 441 User Manual download pdf (Page 35)

– 31 –

7-3. Releasing a Locked Cutter (Auto Cutter Mode only)

If the auto cutter locks up or fails to cut the paper, follow the steps below.

WARNING

Since working on the cutter may be dangerous, be sure to turn off the printer ﬁrst.

(1) Set the power switch to OFF to turn off the printer.

(2) Ordinarily, a locked cutter will recover automati

cally by closing all the covers and turning the power

back ON.

Recovery means that the locked cutter has been

released, so steps (3) and thereafter are unneces

sary. If the cutter has not recovered, proceed to

step (3).

(3) Pull the cover open lever towards you, and open

the printer cover. The printer cover may not open

due to the cutter being locked. In this case, follow

steps (4) and (5) to ﬁrst open the front cover and

remove the tear bar. If the printer cover opens,

proceed to step (6).

Note: Since the print head is hot immediately

after printing, be sure not to touch it. On

an auto cutter model, a paper cutter is

located at the paper outlet slot. Be careful

not to touch the cutter blade.

(4) Open the front cover by holding the ﬁnger grips

on both ends of the cover and lifting it up.

(5) Remove the two screws to remove the tear bar.

Front cover

Screws

Tear bar

Printer cover

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

No comments

Oki Pos 441 User Manual Page 35