Oki Pos 441 User Manual download pdf (Page 28)

– 24 –

6-4. Adjustment Mode

There are the following seven adjustment modes.

The device will enter the adjustment mode if your turn it on while pressing the FEED switch.

(1) The Self Printing Mode is entered by releasing the FEED switch after the buzzer sounds

once. (Refer to Section 6-4-1.)

(Holding down for 2 more seconds)

(2) Adjusting the Dot Alignment Mode is entered by releasing the FEED switch after the buzzer

sounds twice. (Refer to Section 6-4-2.)

(Holding down for 2 more seconds)

(3) The Hexadecimal Dump Mode is entered by releasing the FEED switch after the buzzer

sounds three times. (Refer to Section 6-4-3.)

(Holding down for 2 more seconds)

(4) The Black Mark Sensor Alignment Mode is entered by releasing the FEED switch after

the buzzer sounds four times. (Refer to Section 6-4-4.)

(Holding down for 2 more seconds)

(5) The Near End Sensor Adjustment Mode is entered by releasing the FEED switch after the

buzzer sounds ﬁve times. (Refer to the separate Speciﬁcations Manual for details.)

(Holding down for 2 more seconds)

(6) The Memory Switch Manual Setting Mode is entered by releasing the FEED switch after

the buzzer sounds six times. (Refer to the separate Speciﬁcations Manual for details.)

(Holding down for 2 more seconds)

(7) The Memory Switch Override Mode is entered by releasing the FEED switch after the

buzzer sounds seven times. (Refer to the separate Speciﬁcations Manual for details.)

(Holding down for 2 more seconds)

Returns to (1).

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Comments to this Manuals

No comments