Oki B4100 User Manual Page 410

  • Download
  • Add to my manuals
  • Print
  • Page
    / 637
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 409
40055101TH Rev.4 410 /
A3.2.8 M17 Circuit Diagram (Page 9/17)
1. Block diagram
The circuit diagram shown on page 9/17 consists of the following connectors:
Connector CN6 that provides an interface between M17 board and NCU board.
Connector CN7 that provides an interface between M17 board and external electro-mechanical
devices (PC1 and PC2).
Connector CN9 that provides an interface between M17 board and OPE (O5W) unit.
Figure A3.2.9 shows an interface between M17 board and NCU board.
Figure A3.2.10 shows an interface between M17 board and OPE unit.
Figure A3.2.11 shows the related signals of PC1 and PC2.
2. Function
1) External status supervising interface (PC1/PC2)
External status is detected by the photocouplers (PC1/PC2) in the mechanism and the signal is
output to the input port of CPU via this interface circuit.
PC1: Presence of document on hopper.
When sub-power supply is applied to the fax machine, this signal is output to OPE unit
which will control the main-power supply.
PC2: Presense of document at scanning position.
3. Others
NCU interface signal
CML : Line seizure control signal
DP : Dial pulse control signal
SR : Control signal for connection between LINE and TEL terminals
MUTE : Control signal for pulse dial improvement and bell shunt replay
PP : Relay control signal for special service code detection at parallel pickup or
remote reception
PBXE : Control signal for connecting one of LINE terminal to the PBXE terminal
OH2 : Detection of off-hook of terminal connected to TEL-1 or TEL-2
OH1 : Output upon circuit current detection after fax line seizure
RP : Receiving sensistivity determination terminal
RI : Ringing detection signal
S : Send signal (picture data/protocol/tonal signals/PB tone etc.)
R : Received signal (picture data/protocol/tonal signals etc.)
OPE interface signals
TXDOPE : This signal transmits sequencially the contents of each data of TXD (LED
on/off information, etc.) to OPE in serial data from CPU.
RXDOPE : This signal transmits sequencially the contents of each data of RXD (key
code information, etc.) to CPU in serial data from OPE.
OPECHK : Use to monitor the operation of the OPE unit.
OPERST : Reset signal for OPE unit
WAKEUP-N : Wakeup signal
PSMODE : Power Save Mode off signal from OPE.
MP/OFF : Main Power On/Off signal to Main Power Supply Unit.
MPREQ : Main Power off signal from CPU.
Page view 409
1 2 ... 405 406 407 408 409 410 411 412 413 414 415 ... 636 637

Comments to this Manuals

No comments