Oki C3400 User Manual Page 33

  • Download
  • Add to my manuals
  • Print
  • Page
    / 35
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 32
Network User’s Guide for C3400n and C3530 MFP
Troubleshooting - 33
T
ROUBLESHOOTING
The network addresses used in this manual are examples only. Network
addresses used in your installation must be generated from your own
network.
S
ELF
-
DIAGNOSTIC
TEST
P
RINTER
DOES
NOT
PRINT
> Check that your printer is switched on.
> Check the printer status.
> Ensure that the printer is connected to your computer.
NG
IS
PRINTED
IN
THE
SELF
-
DIAGNOSTIC
TEST
If NG is printed in the self-diagnostic test or a Flash ROM Check Registers NG:
1. Turn the printer off for 15 seconds and then on again.
2. Press the reset button, located close to the Network Interface Panel at
the back of your printer, to re-initialize it.
TCP/IP
C
OMPUTER
CANNOT
FIND
THE
NETWORK
INTERFACE
CARD
Carry out the following procedures to verify the printer settings:
> Turn the printer off for 15 seconds and then on again.
> Confirm the network interface is enabled on the printer.
> Check there is a response to the PING command.
> Ensure that the network cable is correctly connected and that the
green LED close to the printer’s network interface is lit. If not, change
the cable and try again.
> Run the “Self-diagnostic test” on page 7.
> Check the IP Address, Subnet Mask and Gateway are correct.
> Ensure that the TCP/IP protocol is set to Enable.
> Reset the network interface card to factory default settings.
> If DHCP, BOOTP and RARP are not used, ensure they have been set to
Disable.
Page view 32
1 2 ... 28 29 30 31 32 33 34 35

Comments to this Manuals

No comments