OKI CX3641 MFP User Manual download pdf (Page 2)

7. Use the three screws provided to attach the fax

board to the printer.

8. Attach the fax board cable to the connector

labeled J470 FAX CONNECTOR (1) on the

printer board.

9. Remove the tape mask from the LINE jack on

the side of the printer.

10. Close the access

door and tighten the

thumbscrews.

Important!

The ferrite core is an FCC requirement.

In order to reduce electromagnetic interference—

“noise” that interferes with TVs or other

appliances —you must place the included ferrite

core on the telephone cable.

11. Snap the ferrite core onto one end of the

telephone cable, then plug that end of the cable

into the LINE jack on the side of the printer.

Attach the other end of the cable to the phone

line.

12. Peel the backing off the self-adhesive FCC label

and attach it to the back of the printer.

13. Carefully push the printer back into the unit.

and reattach it to the bumper brackets on the

stand.

14. If you have the optional finisher, push it back

onto the printer until it latches.

15. Turn the scanner and the printer back on.

Walk-up Faxing

See the “FAX“ section in your Advanced Technical

User’s Guide for information on walk-up faxing.

1 2 3 4 5 6 7 ... 11 12

No comments

OKI CX3641 MFP User Manual Page 2