Oki 8100e User Manual download pdf (Page 79)

UNIX 79

UNIX

Overview

The OkiLAN 8100e supports many protocols such as LPD, FTP, TELNET,

SNMP and IPP, and works within the UNIX environment.

To use the network card within the UNIX environment, the following

steps are required:

Configuration

Network Interface card setting

The first step in installing the network card under UNIX is to set up the

IP address, Subnet Mask and Gateway. This section explains one way

to set them up from a UNIX workstation.

> The network addresses used in this manual are shown as

examples only. Network addresses used in your installation

must be generated for your own network.

> Login as [root] to change the configuration of the OkiLAN 8100e.

> If an incorrect IP address, Subnet Mask or Gateway is entered,

the network may go down or other damage may occur. Check the

address with your network manager.

The following explanation uses Sun Solaris 2.8 (Solaris 8) as an

example. The actual commands may differ between versions of UNIX,

so refer to the workstation manuals for more information.

1. Log in as [root] to the workstation

> If you do not have superuser rights, the network manger should

conduct the configuration.

2. If the OkiLAN 8100e does not have an IP address already

assigned, use the arp command to set a temporary IP address.

Example: for IP address 192.68.20.127 and network card address

00:80:87:01:00:D2

# arp –s 192.168.20.127 00:80:87:01:00:D2 temp

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 105 106

No comments

Oki 8100e User Manual Page 79